The Conext™ Configuration tool is used by system installers to simplify the task of system configuration and reduce installation time. It’s a PC-based software tool that works on systems that include the Conext™ XW, Conext™ XW+, Conext™ SW, and peripherals.

The Conext Configuration tool is not meant to replace the Conext™ System Control Panel (SCP), Conext™ ComBox or any other monitoring devices.  Those monitoring devices may still be required to monitor the Conext System and components.

Conext Config Tool Software_AI (Anti-Islanding) is used when 2 or more inverters are installed in parallel on a single phase connection (See Conext XW+ Multi-Unit Power System Design Guide under the downloads section (Technical Publications). It is also used if there is a specific requirement by a utility.

Note: Adjustment of AC anti-islanding parameters should only be done after consultation with the power utility or authority having jurisdiction.

Note: The configuration tool should not be used with Conext ComBox in-network especially when performing Firmware Upgrades. Use either the Conext ComBox or the configuration tool to complete firmware upgrades – but not both.